Friday, April 12, 2024

Penn State team uses cold sintering to reprocess solid-state composite electrolytes


A team at Penn State has reported using cold sintering to reprocess solid-state composite electrolytes.

According to research published in an open-access paper in the journal ChemSusChem, the technique was used to reprocess Mg- and Sr-doped Li7La3Zr2O12 with polypropylene carbonate (PPC) and lithium perchlorate (LLZO–PPC–LiClO4). 

The low sintering temperature allows co-sintering of ceramics, polymers, and lithium salts, leading to the re-densification of the composite structures. Reprocessed LLZO–PPC–LiClO4 exhibits densified microstructures with ionic conductivities exceeding 10−4 S/cm at room temperature after five recycling cycles. All-solid-state lithium batteries fabricated with reprocessed electrolytes exhibit a high discharge capacity of 168 mAhg−1 at 0.1 C, and retention of performance at 0.2 C for over 100 cycles.

We directly reprocessed LLZO–PPC–LiClO4 composite electrolytes using cold sintering and demonstrate recyclability with modest loss in ionic conductivity. Cold sintering, a low-temperature sintering technology (<300° C), is a process that enables the densification of composites comprised of ceramics, polymers, and salts. Driven by pressure and heat, densification happens with the assistance of a transient liquid phase, which functions as a medium to aid in the dissolution and regulate the precipitation and nucleation processes,” the researchers wrote.

Source: Green Car Congress, ChemSusChem



from Charged EVs https://ift.tt/jCL4boh

No comments:

Post a Comment

The advantages of using electric-PTOs in vehicles with or without an ICE engine: Watch Now

Sponsored by Parker. Commercial work trucks have historically utilized mechanical Power Take Off units (PTOs) to transfer power from the d...